Panerai Watch Repair & Servicing in Singapore

Movement overhaul starts from S$400 — the exact quote is confirmed after assessment, as price depends on the calibre (P.900, P.9010, or OP-series), complication level, and overall condition. Crown device service, crystal replacement, and pressure testing are quoted individually after inspection. Authorised Panerai service centres charge a significant premium with typical turnaround of 3–6 months.

Movement overhaul typically takes 14–21 working days. Panerai's large cushion-shaped cases require careful disassembly of the crown device — bridge, lever, and all three gaskets — which adds time over simpler watch types. Crown device and gasket replacement alone: 3–5 working days. Crystal replacements: 1–3 working days.

Panerai recommends servicing every 5 years. In Singapore's tropical climate — high humidity and temperature swings — we recommend every 4–5 years. The crown device gaskets in particular degrade faster in humid conditions. Signs your Panerai needs service: gaining or losing more than ±15 sec/day, stiff or sticky crown lever, reduced power reserve, any moisture condensation under the crystal, or visible corrosion around the crown tube.

We service all Panerai calibres including the in-house P.900 (3-day power reserve, 21,600 vph), P.9010 automatic, P.999, and P.3001. We also fully service the OP-series movements (OP I through OP XIV) based on the Unitas 6497 and ETA 6497/6498 hand-winding platform, and ETA-based movements in older PAM references.

No — we are an independent watch repair workshop. If your Panerai is still under warranty, we recommend contacting Panerai directly to preserve your warranty coverage. For out-of-warranty watches, an independent workshop delivers professional-standard service at significantly lower cost and with far faster turnaround than the authorised centre — 14–21 working days versus 3–6 months.

We service the full Panerai range: Luminor Base, Luminor Marina, Luminor GMT, Luminor Due, Luminor 1950, Luminor Base 8 Days, Radiomir, Radiomir 1940, Radiomir Black Seal, Radiomir California, Submersible Automatic, Submersible Chrono, Lo Scienziato, Luminor Carbotech, and vintage PAM references including early OP-calibre hand-wind models.

The crown-locking device is the patented bridge-and-lever mechanism unique to all Luminor cases. The lever bridges over the crown and locks it flush against the case, creating a secondary watertight seal in addition to the crown tube gasket. The device has multiple components — bridge, spring lever, locking pin — and three separate gaskets. At every service, all crown device gaskets must be replaced and the mechanism pressure-tested to confirm water resistance is restored. Neglecting this causes the crown tube area to leak, and water in a Panerai movement corrodes quickly. The Radiomir uses a simpler screw crown without a bridge, but still requires crown tube gasket replacement at each service.

Yes. Panerai Submersible models are rated to 300m water resistance. Leaks typically enter through a deteriorated crown device gasket, crown tube O-ring, or caseback gasket. We disassemble the crown device, replace all gaskets, inspect the caseback seal, and pressure-test to rated depth after service. If water has already entered the movement, the movement is also cleaned and serviced to prevent corrosion damage. Do not delay — water in a Panerai movement causes rapid rust on both the OP-series and P.900 components.

We are at People's Park Complex #03-62, 1 Park Road, Singapore 059108 — a 1-minute walk from Chinatown MRT Station Exit C. Open daily 1:30PM–7:00PM, including weekends and public holidays. No appointment needed — walk in with your Panerai for a free assessment and written quote.